pouët.net

The Party 4 Report by Keen Like Frogs & legend design

 ÛÛÛßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßßÛÛ
 Ûß         °±²ÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛ²±         Û
 Û          ±²ÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛ ßÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛ²±°         Û
 Û                 ÜÜÜÜ                 ßÛÜ                                   Û
 Û                 ÛÛÛÛ   °°±²ÛÛÛÛÛÛÛÛÛ  ßÛÝ °±²ÛÛÛÛÛÛÛ °±²Û  ÛÛÛÛ            Û
 Û                 ÛÛÛÛ   °±²ÛÛÛÛÛÛÛÛÛÛ   ß  ±²ÛÛÛÛÛÛÛÛ ±²ÛÛ  ÛÛÛÛ            Û
 ÛÞÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÝÛÛÛÛÞÛݱ²ÛÛ      ÛÛÛÞÛÛÛÛݲÛÛ   ÛÛÛÛ ²ÛÛÛ  ÛÛÛÛÞÛÛÛÛÛÛÛÛÛÛÝÛ
 Û                 ÛÛÛ²   ÛÛÛÛ ÛÛÛÛÛÛÛÛ      ÛÛÛÛÛÝÛÛÛÛ ÛÛÛÛÛÝÛÛÛ² Ä[bRi/ld]Ä Û
 Û                 ÛÛ²±   ÛÛÛÛ ßßßßßßßß      ÛÛÛÛÛÝÛÛÛÛ       ÛÛ²±            Û
 Û                 Û²±°   ÛÛÛÛ [REPORT]            ÛÛÛÛ       Û²±°            Û
 Û                                                                            Û
 Û             -[ A KEEN LIKE FROGS AND LEGEND DESIGN 95 PRODUCTION ]-       ÜÛ
 ÛÛÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÜÛÛÛ


 ==============================================================================
 ==[TABLE OF CONTENTS]=========================================================

   I)......... Introduction
   II)........ System requirements
   III)....... Command line parameters
   IV)........ Configuring the THE PARTY IV REPORT
   V)......... Using the config program
   VI)........ Troubleshooting
   VII)....... Commercial disclaimer
   

 ==[1]====================================================================[1]==
 ==[INTRODUCTION]==============================================================

   Welcome  to  the PARTY IV REPORT  documentation file. Please  read  this 
   _before_ starting the program.
   It contains some useful informations  to avoid system crashs  and/or un-
   necessary malfunctions.


 ==[2]====================================================================[2]==
 ==[REQUIREMENTS]==============================================================

   The PARTY IV REPORT requires at  least  a 386 to run at all.
   A Gravis Ultrasound Card is needed for music and sound output. Again, it
   will run without this one, but well.. you'll miss something !
   The Gravis needs to be equiped with 512kb of dram memory (256k are okay, 
   too. In this  case you are not able  to listen to all  songs delivered). 
   To summarize here's the optimum system requirement:

   386-SX 16+
   VGA 
   GUS       (512kb for full sound support)
   544kb     (free conventional memory with installed himem.sys)
   1900 KB XMS


 ==[3]====================================================================[3]==
 ==[COMMAND LINE PARAMETERS]===================================================

   There are four built in command line parameters.

    REPORT -?   - Get the helpscreen (all this is displayed there, too)

    REPORT -R   - Reconfigure the report

    REPORT -AD  - Adaptec adjusting, needed for some adaptec controllers

    REPORT -S#  - Optional Sounddevice usage (Use this if you encounter
                  problems using the configuration program)
                  (0) Other soundboards
                  (1) Gravis Ultrasound board

    REPORT -A   - Adjust your GUS port address
                  Example: Report -A240

    REPORT -C   - Disable GUS presence testing. Use this parameter to
                  override the inbuilt GUS testing. May be useful, when
                  trying to get rid of some problems concerning sound.


 ==[4]====================================================================[4]==
 ==[CONFIGURING]===============================================================

   First of  all, in order to run the program, start with a clean boot. In-
   stall HIMEM.SYS, nothing else is needed nor used by THE PARTY IV REPORT.
   So don't include any V86 mode manager in your configuration files.
   The included  config program is used to configure your machine settings.
   It starts the first  time you run the  report, or each time  you deleted
   the saved configuration  file called "report.cfg". If you, for  example,
   changed your hardware config, delete the generated configuration file.
   Having started the  configuration, the system will  be checked, this can
   take a short while, so don't think it to be crashed.
   The following screen displays a list of detected hardware items.
   A RED underline  indicates you may neither  save nor start with the cur-
   rent configuration. Please reconfigure your items !
   If there's something listed  as UNKNOWN, or UNDETECTED, please switch to
   the  corresponding field  and choose  the configuration manually. How to
   alter a specific item is explained in the next chapter.
   The detectionfailure results from yet undetectable cards and or CPUs you
   are using. A known phenomen  is the detection of the  DX/4 cpu. Just put
   in 486 into the appropriate configuration field, that should do the job.


 ==[5]====================================================================[5]==
 ==[USING THE CONFIG]==========================================================

   Choosing other configurations is done by either using the mouse  or key-
   board. Using the mouse is the more comfortable way, not much to  explain
   to it, try it out.
   Using the keyboard is a bit more tricky, do the following:
   To  choose another config, just press the highlighted key to the corres-
   ponding  field. You'll notice  a change in the field. To scroll down the
   list press SHIFT <key>.
   Saving or starting the program is done by pressing CTRL A or CTRL Q.
   To load  a previously  saved config,  press CTRL L or  use the  mouse to
   point the button !


 ==[6]====================================================================[6]==
 ==[TROUBLESHOOTING]===========================================================

   Q: The config program reports UNKNOWN in some fields
   A: Switch to the corresponding field and try to find your configuration.
      If it's not included, try something other. It may  work nontheless...

   Q: I get no sound during the execution of THE PARTY IV REPORT
   A: Do you  have enabled the GUS in  the  config program, does it have at
      least 256kb of memory on board ? If not, do  so. Soundblaster owners, 
      switch to the NOSOUND option.
      Note for Soundblaster users: We  will not  support that  card in this
                                   program sorry for that, but we think GUS
                                   is the only  card worth  being supported
                                   at the moment.

   Q: What are the SINDBAD EXECUTION FAULTS ?
   A: Sindbad controls  the functioning of THE PARTY IV REPORT, so if some-
      thing is wrong or missing he's the one to  report it. The easiest way 
      to correct the problems : Do what he tells you, for example
                       SINDBAD EXECUTION FAULT 001
                         CPU ALREADY IN V86 MODE
      Reboot without anything like, QEMM, EMM386, 386MAX ...


 ==[7]====================================================================[9]==
 ==[COMMERCIAL DISCLAIMER]=====================================================

   THE PARTY IV REPORT, copyright 1995 by KEEN LIKE FROGS & LEGEND DESIGN,

   All means  of publishing this production on CD ROM media is  prohibited 
   as long as no written agreement with SOUND SOLUTIONS  and the PRODUCERS
   is made.

   This software  is provided "as is" without warranty of any kind, either
   expressed  nor  implied, including, but  not limited  to, warranties of
   merchantability and fitness for  a particular purpose. In no event will
   any of the authors or copyright  holders be liable for any damages cau-
   sed by the use, or inability to use, of this production.

   THE PARTY IV REPORT may  be freely distributed  as long as no  money is 
   charged for it, no  modifications to the distribution package  are made 
   and no  attempt is made to restrict  further copying, distribution  and 
   using of THE PARTY IV REPORT. If you have problems with this, or do not 
   understand this, contact us.


 ==[END OF TEXT]==============================================[Brian / LD '95]=